System Setup And Connections; Setup Overview And Background - Jabra GO 6470 User Manual

4.

SySteM SetuP and connectionS

this chapter explains how to assemble your Jabra GO solution and connect it to your other office equipment.
4.1

SetuP oveRview and backgRound

Connection Diagram
Figure 5: Jabra GO base connections
Using a Headset with a Desk Phone
to accommodate the full range of desk phones in use, Jabra GO is able to adapt itself to your phone by offering
the following settings:
- Termination standard
though all desk phones use the same type of cable to connect the handset to the phone body, the internal
wiring standard for this cable varies according to desk-phone model. Jabra GO supports all of the possible
combinations and will assist you in finding the right one.
- Microphone level
the sound volume sent from your Jabra GO base must be adjusted to ensure that it is neither too quiet nor too
loud for your desk-phone model.
- Electronic hookswitch or GN1000 Remote Handset Lifter
an electronic-hookswitch adapter or handset lifter will enable you to answer the phone or hang up using only
the button on your headset or its docking operations. these are available as optional accessories for Jabra GO;
the best choice for you will depend on your desk-phone model.
the Jabra GO setup wizard will help you to make each of the above settings.
Using a Headset with a Mobile Phone
to enable bluetooth communication between your headset and mobile phone, you must pair the two units. the
Jabra GO setup wizard will help you to do this.
Using a Headset with a Softphone
softphone support is provided with Jabra GO 6470. to use Jabra GO 6470 with a softphone, you must connect
the Jabra GO base to your pC via a Usb cable and install the Jabra pC suite collection of software and softphone
drivers on your pC. the Jabra GO setup wizard will remind you to do this. you might need to install the actual
softphone on your pC — if in doubt, please contact your It administrator.
Jabra GO 6470 User manUal
13