Replacing The Earbud; Using The Headset With Other Bluetooth Devices - Jabra GO 6470 User Manual

Attaching the Head- or Neckband
to attach the head- or neckband:
1. remove the current wearing-style attachment, if any.
2. align the earbud and fitting of the headset with the matching holes on the head- or neckband and press until
it clicks into place.
3. put on the headset and rotate the microphone until it is as close as possible to your mouth.
Figure 26: Attaching the Jabra GO headset to a head- or neckband
Removing a Wearing-Style Attachment
to remove a wearing-style attachment, perform the opposite procedure to that described above for attaching it.
7.3

RePlacing the eaRbud

after extensive use, the earbud of the Jabra GO headset may become worn, dirty and/or uncomfortable. two
extra, differently shaped earbuds are included with your headset. Otherwise, you can order replacement earbuds
from Gn at any time.
to remove the earbud, hold the headset with the earbud facing you and twist the earbud gently anti-clockwise
until it comes free. then align the replacement earbud onto the same fitting and gently press it down until it
clicks into place (do not rotate).
7.4

uSing the headSet with otheR bluetooth deviceS

Pairing the Headset with a Mobile Phone
to use bluetooth, you must set up the wireless communication between the Jabra GO headset and your mobile
phone by pairing them. the setup wizard helps you to do this during initial setup, but can also pair the headset
manually at any time using the procedure below.
1. If your headset is currently turned on, turn it off by pressing and holding on its multifunction button for about
4 seconds — until its led gives four quick flashes and then turns off.
2. put your (powered-off ) headset in pairing mode by pressing and holding on its multifunction button for about
4 seconds — until its led lights a constant blue.
4 sec.
4 sec.
Jabra GO 6470 User manUal
33