The Jabra Link 350 Usb Bluetooth Adapter; Jabra Link 350 Usb Bluetooth Adapter Diagram; Purpose Of The Usb Bluetooth Adapter; Jabra Link 350 Usb Bluetooth Adapter Setup And Connection - Jabra GO 6470 User Manual

10.

the JabRa link 350 uSb bluetooth adaPteR

the Jabra lInK 350 Usb bluetooth adapter is available as an accessory for your Jabra GO 6470 solution. this
chapter explains how to use the Usb bluetooth adapter.
10.1

JabRa link 350 uSb bluetooth adaPteR diagRaM

1. Activity indicators (LEDs)
2. USB plug
3. Multifunction button
Figure 46: Jabra LINK 350 USB Bluetooth Adapter
10.2

PuRPoSe of the uSb bluetooth adaPteR

the Jabra lInK 350 Usb bluetooth adapter connects to your computer and communicates with your headset via
bluetooth. It provides the following features:
- basic bluetooth connection
- softphone control
- wideband audio
- headset configuration
though it is also possible to pair your Jabra GO headset with any standard bluetooth device — including
bluetooth pC cards — this type of pairing provides only the basic connection (the first point listed above) and
you may also experience compatibility issues. softphone-control, wideband audio and headset-configuration
features require the Jabra lInK 350 Usb bluetooth adapter.
10.3

JabRa link 350 uSb bluetooth adaPteR SetuP and connection

to connect the Jabra lInK 350 Usb bluetooth adapter and set it up for use with your computer and headset:
1. plug the Usb bluetooth adapter into the free Usb port on your pC.
the Usb bluetooth adapter installs automatically when you plug it in.
Note: even though the basic installation is automatic, you need to have installed the Jabra pC suite software
before the adapter can be used with any softphones (each type needs a specific driver). the Jabra pC suite
software is also required for downloading new firmware to the adapter.
2. after a few seconds, an led on the Usb bluetooth adapter will indicate the current status of the unit. do one
of the following, depending on the status indicated by the led:
- Constant green light:
the headset and Usb bluetooth adapter are already paired and connected and the pC's softphone is the
current target. Go to step 3.
- Constant yellow light:
the headset and Usb bluetooth adapter are already paired and connected and the pC's softphone is not
the current target. Go to step 3.
- Slow-flashing green light:
the headset and Usb bluetooth adapter are paired but not (yet) connected. make sure your headset is
switched on and close by and then tap the button on the adapter. when the light changes to constant
green or yellow (see above), your headset is connected.
- Constant blue light:
the headset and Usb bluetooth adapter are not yet paired. the adapter is in pairing mode. this means that
you need to pair the headset to the Usb bluetooth adapter before you connect them. see the section 10.4:
Pairing the Adapter and Headset for instructions.
3. you are now ready to use your headset with your computer. If you have not already done so, then install the
Jabra pC suite software as described in Chapter 5: Installing and Running the Jabra PC Suite; see also the pC
suite online help.
2
3
Jabra GO 6470 User manUal
1
55