Replacing The Batteries; "Pair" (Connect) With Your Bluetooth Mobile Phone; Making A Call; Ending A Call - Jabra SP100 User Manual

SP100 User Guide_NA.qxd 5/7/04
3

Replacing the batteries

In time, rechargeable batteries gradually lose the ability to deliver their full power. To
maintain the performance of your JABRA SP100 it is advisable to periodically fit a new
pair of rechargeable batteries. Follow these instructions for fitting either a new set of
rechargeable 1.2-volt (AA) batteries or a pair of non-rechargeable 1.5 volt (AA) Alkaline
batteries. If you choose to use non-rechargeable batteries DO NOT use the AC
adapter or the vehicle power charger with the JABRA SP100.
1. Remove the back cover from the speakerphone using a screwdriver and insert both
rechargeable batteries (or non-rechargeable Alkaline batteries) into their individual
battery compartments as indicated. Re-attach the back cover to the speakerphone.
(See Fig. 2)
2. Rechargeable batteries must be fully charged before the speakerphone is used.
4 "Pair" 2 (Connect) with your Bluetooth mobile phone
1. Turn the JABRA SP100 on.
2. Press and hold and the mute button until you see a solid blue light
(approximately 5 seconds), then release.
3. Set your Bluetooth phone to "discover" the speakerphone by following your
phone's instruction guide. Typically, the steps involve going to a "setup" , "connect" ,
or "Bluetooth" menu on your phone and then selecting the option to "discover" a
Bluetooth device*. (See example from a Sony Ericsson T610 in Fig. 3)
4
2:46 pm Page 4
Fig. 2
Fig. 3
4. Your phone should find the "JABRA SP100" speakerphone and ask if you want to
pair with it. Confirm by pressing "yes" or "ok" .
5 Enter passkey or PIN 3 = 0000 (4 zeros), then press "yes" or "ok"
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing blue every 3 seconds. If unsuccessful, the light remains
solid, and you'll need to re-attempt pairing. (See steps 3–5 above)
* Phone-specific pairing instructions can be found online at www.jabra.com/fscs
USING YOUR JABRA SP100
Before using your JABRA SP100, ensure that the batteries are charged and the JABRA
SP100 is paired with your Bluetooth mobile phone and switched on.
5

Making a call

Using your mobile phone's keypad
1. Dial number on keypad.
2. Press phone's "send" key.
Using voice-dialing (if supported by your phone)
1. Press and release once. You'll hear 1 short beep while doing this.
2. You'll then hear the voice-activation tone; say the name of the person you wish to call.
NOTE: Record voice tag via your mobile phone.
6

Ending a call

•
Press and release once
OR
•
End call from your mobile phone's keypad
7

Answering a call

•
After you hear the ring tone, press and release
OR
•
Answer the call with your mobile phone's keypad. You may then need to transfer the
call to the speakerphone by pressing and releasing
your phone)
once
once (depending on
5