The Lcd Screen; Resetting The V300; Phone Functions; Making A Call - ZyXEL Communications V300 Series User Manual

The following table describes the rear panel hardware.

Table 5 Base Panel Hardware

LABEL DESCRIPTION
1 Wall-mounting holes
2 Handset port
3 Reset button
4 Cable channel

2.2.1 The LCD Screen

When the V300 is on, the LCD (Liquid Crystal Display) screen shows either the status screen,
a phonebook screen, or a configuration menu.
The LCD menus allow you to configure and control the V300. See
details on configuring the V300 via the LCD menus.

2.2.2 Resetting the V300

If you want to reset the V300 to its factory defaults (if you forgot the web configurator
password, for example) press and hold the RESET button for approximately ten seconds. The
V300 restarts automatically.
If you reset the V300, all settings return to their factory defaults. All data stored
in the V300 (phonebook entries, for example) will be lost.

2.3 Phone Functions

This section describes how to use your V300's basic telephone functions. See
page 41 for information on the using the V300's LCD screen menus and
for information on how to use the V300's phonebook.

2.3.1 Making a Call

1 Start the call:
• If you want to use the handset:
Lift the handset.
• If you want to use the speakerphone:
V300 User's Guide
Use these to hang the V300 on a wall. See the wall-mounting
appendix for details.
Use this to attach the included handset cable's RJ-11
connector.
Use this to return the V300 to its factory default settings. See
the appendix on product specifications for the default settings.
Note: If you do this, all configuration changes and
data on the V300 are lost, including
phonebook records.
Clip the V300's handset cable into this.
Chapter 2 Hardware
Chapter 3 on page 41 for
Chapter 3 on
Chapter 4 on page 45
35