Table 102 Menu 11.3: Remote Node Network Layer Options - ZyXEL Communications P-793H User Manual

P-793H User's Guide
The following table describes the fields in this menu.

Table 102 Menu 11.3: Remote Node Network Layer Options

FIELD
IP Address
Assignment
IP Address
IP Subnet Mask
Gateway IP Addr
Rem IP Addr
Rem Subnet Mask
My WAN Addr
NAT
Address Mapping Set This field is enabled if NAT is Full Feature. Specify which address mapping set
Metric
Private
RIP Direction
274
DESCRIPTION
Select Dynamic if your ISP did not give you a fixed (static) IP address. Select
Static if your ISP gave you a fixed (static) IP address. The next three fields are
not available if you select Dynamic.
These fields appear if you selected Ethernet in Encapsulation in menu 11.
Enter the fixed (static) IP address provided by your ISP.
Enter the subnet mask provided by your ISP.
Enter the IP address of the gateway provided by your ISP.
These fields appear if you selected PPPoE in Encapsulation in menu 11.
Enter the IP address of the remote (peer) computer to which the ZyXEL Device
connects.
Enter the subnet mask of the remote (peer) computer to which the ZyXEL
Device connects.
Enter the fixed (static) IP address provided by your ISP.
Select None if you do not want to use port forwarding, trigger ports, or NAT.
Select SUA Only if you want to use one or more of these features and have
only one WAN IP address for your ZyXEL Device.
Select Full Feature if you want to use one or more of these features and have
more than one public WAN IP address for your ZyXEL Device.
you want to use for this remote node.
This field sets this route's priority among the routes the ZyXEL Device uses.
The metric represents the "cost of transmission". A router determines the best
route for transmission by choosing a path with the lowest "cost". RIP routing
uses hop count as the measurement of cost, with a minimum of "1" for directly
connected networks. The number must be between "1" and "15"; a number
greater than "15" means the link is down. The smaller the number, the lower
the "cost".
This field is related to RIP. This field determines whether or not the ZyXEL
Device includes the route to this remote node in its RIP broadcasts. If you
select Yes, this route is not included in RIP broadcast. If you select No, the
route to this remote node is propagated to other hosts through RIP broadcasts.
Usually, you should keep the default value.
Use this field to control how much routing information the ZyXEL Device sends
and receives through this connection.
None - The ZyXEL Device does not send or receive routing information through
this connection.
Both - The ZyXEL Device sends and receives routing information through this
connection.
In Only - The ZyXEL Device only receives routing information through this
connection.
Out Only - The ZyXEL Device only sends routing information through this
connection.
Chapter 26 Remote Node Setup