Remote Node Network Layer Options; Figure 151 Menu 11.3: Remote Node Network Layer Options - ZyXEL Communications P-793H User Manual

Table 101 Menu 11.1: Remote Node Profile (node 8) (continued)
FIELD
Telco Option
Allocated Budget(min) Enter the maximum amount of time (in minutes) each call can last. Enter 0 if
Period(hr)
Schedule Sets
Nailed-Up Connection Select this if you want the ZyXEL Device to automatically connect to your ISP
Session Options
Edit Filter Sets
Idle Timeout(sec)

26.4 Remote Node Network Layer Options

Move the cursor to the Edit IP/Bridge field in menu 11.1, then press [SPACE BAR] to select
Yes. Press [ENTER] to open Menu 11.3 - Remote Node Network Layer Options.

Figure 151 Menu 11.3: Remote Node Network Layer Options

IP Options:
IP Address Assignment = Static
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Metric= 2
Private= No
RIP Direction= Both
Multicast= None
IP Policies=
Chapter 26 Remote Node Setup
DESCRIPTION
This section is only enabled for PPPoA or PPPoE connections.
there is no limit. With Period, you can set a limit on the total outgoing call time
of the ZyXEL Device within a certain period of time. When the total outgoing
call time exceeds the limit, the current call will be dropped and any future
outgoing calls will be blocked.
Enter how often (in hours) the Allocated Budget is reset. For example, if you
can call for thirty minutes every hour, set the Allocated Budget to 30, and set
this field to 1.
Enter the schedule sets that apply to this connection.
when it is turned on and to remain connected all the time. This is not
recommended if you pay for your Internet connected based on the amount of
time you are connected.
If you want to specify input and output filter sets for the WAN port, press
[SPACE BAR] to select Yes and press [ENTER]. Menu 11.1.4 appears.
Enter the number of seconds the ZyXEL Device should wait while there is no
Internet traffic before it automatically disconnects from the ISP. Enter a time
interval between 10 and 9999 seconds.
Menu 11.3 - Remote Node Network Layer Options
Address Mapping Set= N/A
Version= RIP-2B
P-793H User's Guide
Bridge Options:
Ethernet Addr Timeout(min)= N/A
273