P-793H User's Guide
24.4 LAN IP Alias
Use menu 3.2 to configure the first network, and you use menu 3.2.1 to configure the other
two networks. Move the cursor to the Edit IP Alias field, press [SPACE BAR] to choose Yes
and press [ENTER] to configure the second and third network.
Figure 145 Menu 3.2.1: IP Alias Setup
Use the instructions in the following table to configure IP alias parameters.
Table 98 Menu 3.2.1: IP Alias Setup
FIELD
IP Alias 1, 2
IP Address
IP Subnet Mask
RIP Direction
Version
Incoming
protocol filters
Outgoing
protocol filters
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm...] to
save your configuration, or press [ESC] at any time to cancel.
264
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
DESCRIPTION
Choose Yes to configure the LAN network for the ZyXEL Device.
Enter the IP address of your ZyXEL Device in dotted decimal notation.
Your ZyXEL Device will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyXEL Device.
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are
RIP-1, RIP-2B or RIP-2M.
Enter the filter set(s) you wish to apply to the incoming traffic between this node and
the ZyXEL Device.
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the ZyXEL Device.
Chapter 24 LAN Setup