Table of Contents
Advertisement
NetAtlas Enterprise Ethernet Switch Manager User's Guide
Figure 130 Routing Configuration: Static Route: Add
The following table describes the labels in this screen.
Table 101 Routing Configuration: Static Route: Add or Modify
LABEL
Active
Name
Destination IP
Address
IP Subnet
Mask
Gateway IP
Address
Metric
OK
Cancel
183
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name for this route. This is for identification purposes only.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the network number
to be identical to the host ID.
Enter the subnet mask for this destination.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
switch that will forward the packet to the destination. The gateway must be a router on
the same segment as your switch.
The metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need not
be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Click OK to save the settings and close this screen.
Click Cancel to discard all changes and close this screen.
Chapter 18 IP Configuration
Advertisement
Table of Contents
