Add Device(S) Manually; Using Snmp - ZyXEL Communications Dimension ES-3124 Quick Start Manual

6.2 Add Device(s) Manually

If you have disabled auto-discovery,
follow the steps below to add your
device(s) manually.
1 Click Insert, MAP Object, Device.
2 In the MAP Object Properties
screen, enter a descriptive device
name and IP address for the device
and then click OK.

7 Using SNMP

Check that you are using SNMP Version
2c (SNMPv2c). If you are not using SNMPv2c, you must uninstall any
previous versions and install SNMPv2c. Refer to RFC 1901 for more
information on SNMPv2c. Follow this procedure to use SNMPv2c.
1 Right-click the Device icon and select
Properties.
2 Click the Access tab.
3 Set the specified fields in the Map
Object Properties screen exactly as
shown in the figure.
Note: For security purposes, it is
strongly recommend to change
the Read Community and
Read/Write Community
defaults.
Write down this information in a secure place so you will not
forget it later.
NetAtlas Enterprise Quick Start Guide
7