Table of Contents
Advertisement
NetAtlas Enterprise Ethernet Switch Manager User's Guide
Figure 74 System Configuration: Remote Management
The following table describes the labels in this screen.
Table 48 System Configuration: Remote Management
LABEL
Services
Port
Apply
Secured Clients Select the check box(es) to enable the client set.
Start
End
Telnet, FTP,
HTTP, ICMP,
SNMP, ICMP,
SSH, HTTPS
Apply
Close
113
DESCRIPTION
This panel displays the services that you may use to remotely manage the switch.
Select the check box(es) to allow remote management using the service(s).
Enter the server port number to use with the corresponding service.
Click Apply to save the changes back to the switch.
To allow a range of computers to use Telnet, FTP, HTTP, ICMP, SSH or HTTPS
services, enter the first IP address in the range here.The default value for a start and
end address is 0.0.0.0, which means you don't care which host is trying to use a
service (Telnet, FTP, HTTP, SNMP, ICMP, SSH or HTTPS).If you enter an IP address
in this field, the switch will check if the client IP address matches the value here when
a (Telnet, FTP, HTTP, SNMP, ICMP, SSH or HTTPS) session is up. If it does not
match, the session is disconnected immediately.
To allow a range of computers to use Telnet, FTP, Web, SNMP or ICMP services,
enter the End IP address in the range here. To allow a single computer to use Telnet,
FTP, HTTP, SNMP, ICMP, SSH or HTTPS services, enter the same IP address here
as in the Start field.
Select the check box to allow the trusted computer(s) in the IP address range
specified above to use this service to manage the switch.
Click Apply to save the changes back to the switch.
Click Close to close the screen.
Chapter 13 System Configuration
Advertisement
Table of Contents
