EUROCOM Nightsky RX415z User Manual page 151

FlexiCharger (Advanced Menu > Advanced Chipset Control)
The sub-menu here allows you to enable/disable the FlexiCharger. The FlexiCharg-
er may be set to automatically start charging your battery when the battery reaches
a certain capacity level (e.g. you could start the battery charge level at 40%).
You can then set the level to stop charging (e.g. 100%), and of course this stop
charge level must be higher than the start charge level.
See the sidebar warning for information on running the FlexiCharger for an ex-
tended period as this is not recommended.
If you leave the FlexiCh-
arger continuously "En-
abled" for a period of
three months or more,
the battery meter's read-
ing accuracy will deteri-
orate.
To reset this, set the
FlexiCharger to "Dis-
abled", and then allow
the battery to completely
discharge (see
FAQ" on page 3 -
before
function again.
Advanced Chipset
Setup Utility - Advanced Menu 5 - 15
BIOS Utilities

FlexiCharger
Warning
5
"Battery
24)
enabling the
Figure 5 - 9
Control >
FlexiCharger