Multiple Rapid Spanning Tree Protocol Status; Figure 48 Mrstp: Status; Table 28 Spanning Tree Protocol: Status - ZyXEL Communications ES-4124 User Manual

ES-4124 User's Guide
Table 27 MRSTP: Configuration (continued)
LABEL
Apply
Cancel

11.6 Multiple Rapid Spanning Tree Protocol Status

Click Advanced Application, Spanning Tree Protocol in the navigation panel to display the
status screen as shown next. See
Note: This screen is only available after you activate MRSTP on the switch.

Figure 48 MRSTP: Status

The following table describes the labels in this screen.

Table 28 Spanning Tree Protocol: Status

LABEL
Configuration
Tree
Bridge
Bridge ID
Hello Time
(second)
110
DESCRIPTION
Click Apply to save your changes to the switch's run-time memory. The switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to reset the fields.
Section 11.1 on page 101
DESCRIPTION
Click Configuration to configure MRSTP settings. Refer to
104.
Select which STP tree configuration you want to view.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this
switch. This switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority plus MAC
address. This ID is the same for Root and Our Bridge if the switch is the root
switch.
This is the time interval (in seconds) at which the root switch transmits a
configuration message. The root bridge determines Hello Time, Max Age and
Forwarding Delay
for more information on MRSTP.
Section 11.3 on page
Chapter 11 Spanning Tree Protocol