ES-4124 User's Guide
46.3.1 Set Port VID
Syntax:
pvid <VID>
where
<VID>
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# pvid 200
46.3.2 Set Acceptable Frame Type
Syntax:
frame-type <all|tagged|untagged>
where
<all|tagged|
untagged>
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports 1 to 5 to accept only tagged frames.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# frame-type tagged
46.3.3 Enable or Disable Port GVRP
Use the
gvrp
GVRP.
The following example turns off GVRP for ports 1 to 5.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# no gvrp
330
=
Specifies the VLAN number between 1 and 4094.
=
Specifies all Ethernet frames (tagged and untagged), only tagged
Ethernet frames or only untagged Ethernet frames.
command to enable GVRP on the port(s). Use the
no gvrp
Chapter 46 IEEE 802.1Q Tagged VLAN Commands
command to disable