ZyXEL Communications ES-4124 User Manual page 288

ES-4124 User's Guide
Table 107 Command Summary: Configuration Mode (continued)
COMMAND
rip
vrrp network <ip-
address>/<mask-
bits> vr-id <1-7>
uplink-gateway
<ip>
service- ftp <socket-
control number>
http <socket-
number> <timeout>
https <socket-
number>
286
DESCRIPTION
Sets the interface to be passive.
passive-iface
A passive interface does not send
<ip-addr/bits>
or receive OSPF traffic.
Enables and enters the RIP
configuration mode.
Leaves the RIP configuration
exit
mode.
Adds aa new VRRP network nd
enters the VRRP configuration
mode.
Exits from the VRRP command
exit
mode.
inactive Disables the VRRP settings.
Sets the time interval (in
interval
seconds) between Hello
<1..255>
message transmissions.
Sets a descriptive name of the
name <name
VRRP setting for identification
string>
purposes.
Activates this VRRP.
no inactive
Disables VRRP preemption
no preempt
mode.
Resets the network to use the
no primary-
default primary virtual gateway
virtual-ip
(interface IP address).
Sets the network to use the
no secondary-
default secondary virtual gateway
virtual-ip
(0.0.0.0).
Enables preemption mode.
preempt
Sets the primary VRRP virtual
primary-
gateway IP address.
virtual-ip
<ip>
Sets the priority of the uplink-
priority <1-
gateway.
254>
Sets the secondary VRRP virtual
secondary-
gateway IP address.
virtual-ip
<ip>
Allows FTP access on the
specified service port.
Allows HTTP access on the
specified service port and defines
the timeout period.
Allows HTTPS access on the
specified service port.
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
Chapter 42 Introducing Commands