Rapid Spanning Tree Protocol Status; Figure 46 Rapid Spanning Tree Protocol: Status; Table 26 Rapid Spanning Tree Protocol: Status - ZyXEL Communications ES-4124 User Manual

Table 25 RSTP: Configuration (continued)
LABEL
Apply
Cancel

11.4 Rapid Spanning Tree Protocol Status

Click Advanced Application, Spanning Tree Protocol in the navigation panel to display the
status screen as shown next. See
Note: This screen is only available after you activate RSTP on the switch.

Figure 46 Rapid Spanning Tree Protocol: Status

The following table describes the labels in this screen.

Table 26 Rapid Spanning Tree Protocol: Status

LABEL
Configuration
Bridge
Bridge ID
Hello Time
(second)
Max Age (second)
Chapter 11 Spanning Tree Protocol
DESCRIPTION
Click Apply to save your changes to the switch's run-time memory. The switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to reset the fields.
Section 11.1 on page 101
DESCRIPTION
Click Configuration to configure RSTP settings. Refer to
104.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this
switch. This switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority plus MAC
address. This ID is the same for Root and Our Bridge if the switch is the root
switch.
This is the time interval (in seconds) at which the root switch transmits a
configuration message. The root bridge determines Hello Time, Max Age and
Forwarding Delay
This is the maximum time (in seconds) a switch can wait without receiving a
configuration message before attempting to reconfigure.
ES-4124 User's Guide
for more information on RSTP.
Section 11.3 on page
107