ColorKey MobilePar HEX 5 User Manual page 10

Stand Alone Control Settings
To use your MobilePar HEX 5 without a DMX Controller, use one of the various
standalone modes below on your Master fixture.
Static Color Programs
To run the MobilePar HEX 5 in a Static color, do the following:
1. Press (Menu) repeatedly to cycle to COLOR SUB
2. Use (<) or (>) to select color 01-48
Static Color Strobe Speed
To adjust the strobe rate, do the following:
1. Press (Menu) repeatedly to cycle to COLOR SUB
2. Use (<) or (>) to select color 01- 48
3. Press (Enter) to cycle program to SPEED
4. Use (<) or (>) to cycle speed 00-09 (00 is open; 01-09 Slow to Fast)
Automatic Program (JUMP)
To run the MobilePar HEX 5 in Automatic Modes, follow the instructions below:
1. Press (Menu) repeatedly to cycle to JUMP SPEED
2. Use (<) or (>) to select Jump Speed (01-09 Slow to Fast)
Automatic Program (FADE)
To run the MobilePar HEX 5 in Automatic Modes, follow the instructions below:
1. Press (Menu) repeatedly to cycle to FADE SUB
2. Use (<) or (>) to select program 01-02
Automatic Program FADE Speed
To adjust the program speed rate, do the following:
1. Press (Menu) repeatedly to cycle to Fade
2. Use (<) or (>) to select desired program 01-02
3. Press (Enter) to cycle program to Speed
4. Use (<) or (>) to cycle Speed 01-09 (01-09 Slow to Fast)
Sound Active Mode
To run the MobilePar HEX 5 in Sound-Active mode, do the following:
1. Press (Menu) repeatedly to cycle to �� SUB
2. Use (<) or (>) to select desired program
MobilePar HEX 5 User Manual – V1
10