Using The Gui - Quantum P4000 User Manual

Using the GUI

3 Verify that the CHM is empty by checking the
GUI (see Chapter 3, Operator
If there is a tape cartridge in the CHM, perform a
place the cartridge in an available bin.
4 Turn off the power switch located below the GUI.
Note: Wait ten seconds before turning on the power switch
again.
The GUI is activated by touching the screen, and is located on the front of
the library. The menus on the GUI allow you to obtain information about
the library, execute library commands, and test library functions (see
figure 24).
The GUI's functions are grouped into the following four screens:
• screen—displays current tape drive, CHM, and load port
Overview
content and activities.
• screen—displays tape drive, storage bin, load port, and gripper
Tapes
inventories.
• screen—contains library configuration and control functions
Operator
(password protected).
• screen—contains reporting functions, system tests, and
Service
service commands (password protected).
Quantum P4000 and P7000 Libraries User's Guide
Chapter 2 Basic Library Operations
Overview
Commands).
Move
Using the GUI
screen on the
command to
2
43