Muratec MFX-1430 User Manual page 373

Message on the display
Cannot store in a secure
box.
Cannot use the same
code for both Read/Write
and Read Only.
Check Paper Source
Check the paper size.
Open & Close Front
cover.
Close XXX Cover
Close XXX cassette
Close the Scanner Unit
Communication error
Communication in
progress.
Contact service for
printer option
Continue to store?
[Yes] [No]
Copy protected
Copy reservation has
been disabled.
Cover Open
DHCP server did not
respond.
Dialing number has not
been set.
Document full
Document stored
Drum should be
replaced.
Enter location.
Enter the end day.
Enter the end time.
Enter the start day.
Enter the start time.
You tried to store a document in an F-code Secure box. If you need to store documents,
use an F-code Bulletin box.
You cannot use the same protect code for "Read/Write" and "Read Only". Enter a differ-
ent one.
The selected paper is not suitable for copying or printing. Select other paper source.
The loaded paper does not match the paper registered in the machine.
Set correct sized paper or change the paper size setting.
Open and close the front cover to reset the printer.
The cover indicated on the display is open or has not been closed securely. Close it
properly.
The paper cassette indicated on the LCD is open or has not been closed securely. Close
it properly.
The scanner unit is open. Close the scanner unit.
A communication error disrupted the reception or transmission. If you were trans-
mitting, press [Stop] to clear the error message and then re-try the transmission. If
you were receiving a fax, try to contact the other person and have him/her re-try the
transmission.
The function is not available during communication. Wait until it ends.
An internal error has occurred. Contact your Muratec dealer.
The document has jammed while being stored into memory. To continue storing press
[Yes], to cancel the job press [No].
Copy is protected.
To copy, set [Copy protect] to [OFF].
During copy protection, Macro program is disabled.
Copy reservation is disable. Wait until the present job is completed.
Close XXX Cover
The cover indicated on the LCD is open or has not been closed securely. Close it prop-
erly.
DHCP configuration failed. Check the network connection. If the LAN cable is not con-
nected, connect it to the machine to connect to the LAN.
If the DHCP server is not installed on your network, turn off the "DHCP setting" and
register the IP address manually.
For more information, refer to the "Network Guide".
You are selecting a non-registered address book number. Check the address book num-
ber and try again.
You tried to store a document in a Batch Tx box, but the machine has reached its capac-
ity (40 documents). Delete unnecessary documents stored or use other Batch Tx box.
You tried to erase a batch box which contains at least one document. To erase a batch
box, erase all the documents stored in the box.
The drum cartridge has run out. Replace with a new drum cartridge.
No destinations are entered. Enter at least one destination to register the setting.
The end forwarding day is not entered in Fax forward setting.
The end forwarding time is not entered in Fax forward setting.
The start forwarding day is not entered in Fax forward setting.
The start forwarding time is not entered in Fax forward setting.
Description / Solution
M & T
AINTENANCE ROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
AI
14-17