Loading Paper - Kyocera KM-2560 Operation Manual

Preparation before Use

Loading Paper

Before Loading Paper
2-34
Paper can be loaded standardly in the two cassettes and the Multi Purpose
Tray. A paper feeder is also available as an option (refer to Chapter 4
Optional Equipment).
When you open a new package of paper, fan the sheets to separate them
slightly prior to loading in the following steps.
1
Bend the whole set of sheets to swell them in the middle.
2
Hold the stack at both ends and stretch it while keeping the entire stack
swelled.
3
Raise the right and left hands alternately to create a gap and feed air
between the papers.
4
Finally, align the papers on a level, flat table.
If the paper is curled or folded, straighten it before loading. Paper that is
curled or folded may cause a jam.
CAUTION:
If you copy onto used paper (paper already used for copying),
do not use paper that is stapled or clipped together. This may damage the
machine or cause poor image quality.
NOTE:
If printouts are curled or not neatly stapled, turn the stack in the
cassette upside down.
Avoid exposing opened paper to high temperatures and high humidity as
dampness can be a cause of problems. Seal any remaining paper after
loading in the Multi Purpose Tray or cassettes back in the paper storage
bag.
If the machine will not be used for a prolonged period, protect all paper
from humidity by removing it from the cassettes and sealing it in the paper
storage bag.
OPERATION GUIDE