Sending Important Documents Before Others (Interrupt Transmission) - Kyocera KM-1650 Operation Manual

Sending Important Documents Before Others (Interrupt Transmission)

Interrupt Transmission lets you send your
documents before others, eliminating the need to
wait until all communications are complete
whenever the fax is currently scheduled for multiple
communications (Broadcast Transmission or
Polling Reception, etc.), or there are other
communications already scheduled in memory
ahead of yours.
Notes
•
•
•
•
•
1
Open the cover plate to the right and press the
Memory Tx. key.
Make sure the Memory Tx. indicator is out (the fax is
in the Direct Feed Transmission mode).
2 Set the documents you want to transmit in the
Document Processor or on the platen.
3 Enter the destination fax number.
4
Press the Start key. The documents will remain in the Document Processor or on the platen, without
being scanned, waiting for the transmitting operation to begin. Once the operation currently in
progress is completed, the transmission operation for your documents will begin automatically.
Interrupt Transmission may only be accomplished to a single destination.
You can schedule up to 50 Interrupt Transmissions (including communications that use the
timer and Interrupt Transmissions) at one time.
Depending on the timing of when you perform the Interrupt Transmission procedure, there are
occasions where your documents may not be sent immediately after the current
communication.
If you want to cancel an Interrupt Transmission, simply remove the documents from the
Document Processor or the platen.
If you press the Stop/Clear key while an Interrupt Transmission is waiting to start, perform the
same procedure as in < If you press the Stop/Clear key during a Standby Transmission in
the Direct Feed Transmission mode... > on page 3-4.
Various Functions of this Fax
:0
Document:
Press START key.
3-7