Kyocera KM-1650 Operation Manual page 172

Various Settings and Registration
Note
If you want to cancel the procedure part way through, press the Reset key. The operation panel will
return to the initial mode settings.
1 Press the System Menu key.
2 Press the
3 Press the Enter key.
4
Press the
Report.
5 Press the Enter key.
6 Press the
set.
The following example is for setting the Delayed
Communication Report.
7
Press the Enter key.
8 Press the
you want that report to be automatically printed out.
The asterisk (*) in the message display indicates the
current setting.
If you want the report to be printed out automatically,
select On.
If you selected TX Transaction or RX Transaction in step 4, it will also be possible to select
Output only be Condition here. In this case, the corresponding report will only be printed out
under those conditions that are explained under the information for that report as shown on the left
side of this page.
9
Press the Enter key. The setting for that report is complete.
> If you want to continue the setting procedure for other reports, repeat steps 6 – 9.
> If you want to perform other setting procedures, select End and then press the Enter key.
> If you are finished making settings, press the Reset key. The operation panel will return to the
7-2
key to select Fax Default.
key or the
key or the
key or the
initial mode settings.
key to select Print
key to select which report to
key to select whether or not
System Menu / Counter
Machine Default
Printer Default
Fax Default
Fax Default:
Line Type
TTI
Print Report
Print Report:
TX Transaction
RX Transaction
Delayed Comm.
Delayed Comm. Report:
On
*
Off
:Tone Dial
:Outside P.
:Condition :Condition
:Off
:On