Modifying Or Deleting Encryption Keys - Kyocera KM-1650 Operation Manual

Other Features of this Fax

Modifying or Deleting Encryption Keys

Note
If you want to cancel the procedure part way through, press the Reset key. The operation panel will
return to the initial mode settings.
1 Perform steps 1 - 3 of Registering New Encryption Keys on page 5-55.
2 Use the keypad to enter the currently registered
administration password (4 digits).
If you enter the wrong password, an error message will
be displayed. In this case, press the Enter key and
enter the correct password.
3 Press the
Key that you want to modify or delete.
4
Perform one of the following procedures.
> Modifying information
(1) Press the Enter key.
(2) Use the one-touch keys to create the 16-digit
(3) Press the Enter key.
> Deleting an Encryption Key
(1) Press the Stop/Clear key.
(2) Press the Enter key.
5
If you want to continue modifying or deleting other Encryption Keys, repeat steps 3 and 4.
If you are finished modifying and deleting Encryption Keys, pess the
End and then press the Enter key. The operation panel will return to the initial mode settings.
5-58
key or the key to select the Encryption
Encryption Key that you want to register.
To clear the currently entered Encryption Key, press
the Stop/Clear key.
Enter Pin Code using # Key.
Program Encryption ID:
End
#01
#02
Encry. Key:786ABC8476EF
16 Digits Required
Enter Encryption Key
key or the key to select