Kyocera KM-1650 Operation Manual page 44

Fax Operation (Basic Use)
<When the documents are set on the platen...>
Whenever you set the documents that you want to transmit on the platen, close the Document
Processor in order to allow the machine to detect the size of those documents. If you are
transmitting information from books or other types of documents that will not allow you to close the
Document Processor, press the Original Size key to manually select the correct size of the
documents to be transmitted.
In addition, any time you set documents on the platen,
a menu like that shown below will appear in the
message display once you press the Start key. In this
case, perform the following procedure.
> If you want to scan more pages...
(1) Replace the scanned document with the next one you want to scan.
(2) Make sure that Yes is selected and press the Enter key.
(3) Press the Start key.
> Once there are no more pages to be scanned...
(1) Press the
(2) Press the Enter key. The fax will begin transmission.
2-8
It is also possible to set the next document(s) in the Document Processor.
If you set the next document(s) in the Document Processor, scanning will begin and, once it is
finished, the fax will automatically transmit all of the documents scanned into memory.
If there are still further documents to be scanned, repeat steps (1) to (3) until all documents are
scanned in.
key to select No.
Continue Scanning:
Yes
No
Continue Scanning:
Yes
No