Media Roll Size; Core; Internal Roll - Intermec EasyCoder PD4 User Manual

Appendix B—Media Specifications

Media Roll Size

Core

Diameters:
Width:
The media must be wound up on the core in such a way that
the printer can pull the end free.

Internal Roll

Max. diameter:
Max. width:
Min. width:
Thickness:
Thicker media may be used, but print quality will be reduced. The
stiffness is also important and must be balanced against thickness to
maintain print quality. Readjustment of the printhead alignment vs the
platen roll may be required (see Chapter 9).
Media rolls to be loaded inside the printer should be wound with the
printable side facing outwards.
The media supply must not be exposed to dust, sand, grit, etc. Any hard
particles, however small, can damage the printhead.
74
38 to 76.2 mm (1.5 to 3 inches)
Must not protrude outside the media.
212 mm
118 mm
25 mm
6 to 250 µm
(8.35 inches)
(4.65 inches)
(1.00 inches)
(2.3 to 9.8 mils)
Intermec EasyCoder PD4—User's Guide