Troubleshooting - Insinger GS 302 Technical Manual

TROUBLESHOOTING

Faults where it is not necessary to call Insinger.
You can rectify minor faults yourself following the
steps described in the table below. If you are un-
able to rectify the fault, contact Insinger service
(1-800-344-4802.)
Do not open any panels or expose any parts of the
machine if tools are necessary to do so. Risk of
electric shock.
Display
The Washer Cannot
Be Switched On
Wash Program
Does Not Start
Dishes Are Not Clean
DOS
Display Shows
Button is Flashing Blue
Undercounter DOC GS 302 1.0 05
PART 5 MAINTENANCE & REPAIR PROCEDURES
®
Cause
Main switch on the machine is not
switched on
Customer's fuses blown
Door not fully closed
Machine not ready for operation
Detergent or rinse aid storage tank is
empty
Filter cartridge and/or scrap screen is
dirty
Wash jets in the wash arms blocked
Lack of detergent or rinse additive
Water stop valve closed
Malfunction
If the dishes have not been sufficiently
pre-rinsed, so much dirt may have accu-
mulated on the scrap screen and the car-
tridge filter that the wash program's op-
eration is interrupted. The wash pump
turns itself off and the program button
flashes blue.
Work on the electrical equipment should only be
performed by service personnel. First disconnect
the washer from the main power switch. Do not
switch the washer on again until the cause of the
fault has been identified.
!
WARNING:
Turn off the main switch on the dishwasher
so it is isolated from the power supply.
Switch on the customer's main switch
Replace the customer's fuses
Close the door
Switch on at the customer's main switch,
open the water stop valve and switch on
the machine
Top off the detergent or rinse storage tank
Clean the filter cartridge and scrap screen
Clean wash jets
Re-fill detergent or rinse additive
Turn off the dishwasher (Press the on-off
switch). Then the display should show Err
and a fault code.
Open the water stop valve and turn the
machine on again.
If the fault message reappears, note the
fault code and contact Insinger Service.
Turn off the machine, the program button
continues to flash.
Remove the screens, clean and replace.
After 2 minutes the flashing will stop. Turn
the machine on again and continue to use.
In order to avoid further problems please
ensure better pre-rinsing.
20
www.insingermachine.com 800-344-4802
Remedy