If You Are Unable To Change Any Values In Setup - HP Kayak XA 05xx Troubleshooting Manual

Clearing the
PC Workstation's
Configuration Memory
HP Kayak XA 05xx PC Workstation —Troubleshooting Your HP PC Workstation
If Your PC Workstation Does Not Start Properly

If you are Unable to Change any Values in Setup

Ensure that you are using the correct password.
If a POST Error Message is Displayed
The Power-On-Self-Test (POST) can detect both an error and a change
to the configuration. In either case, an error code and short description
is displayed. Depending on the kind of error, you will have one or more
of these choices available on screen:
Press to ignore the message and continue.
•
F1
Press to run Setup and correct a system configuration error. HP
•
F2
recommends that you correct the error before proceeding, even if
the PC Workstation appears to start successfully.
Press to accept (validate) the change and update Setup's
•
F4
configuration information.
Press to see more details about the message. After viewing
•
Enter
these details, you will be returned to the original POST display
screen. If the message is actually a change to the configuration you
have made (for example, you have just removed some memory), you
can then press
F4
configuration information. Otherwise, press
message and continue, or press
configuration error. (The number of choices you will have available
are dependent on the kind of error.)
If the PC Workstation then starts, but POST still persists in reporting an
error, clear the current configuration memory values and reinstall the
built-in default values:
1 Turn off the PC Workstation, disconnect the power cables, and
remove the cover. Disconnect the PC Workstation from any
telecommunications network.
a Set the system board switch 6 (CLEAR CMOS) DOWN to clear
the configuration.
b Replace the cover, and reconnect only the power cable.
10 English
to accept the change and update Setup's
to run Setup and correct a system
F2
to ignore the
F1