If You Are Unable To Change Any Values In Setup; If A Post Message Is Displayed - HP Vectra VE 5/xxx - 2 User Manual

If you are Unable to Change any Values in Setup

If the Secure Switch on the system board is set to "closed", you cannot
change any of the values in Setup.
1 Turn off the display, the computer, and all external devices.
2 Unplug all power cords and cables, noting their positions. Disconnect
any telecommunications connection.
3 Remove the cover.
4 Check the system board switches. Refer to "System Board
Connectors and Switches" on page 104. Be sure the Secure Switch is
set to "open".
5 Replace the cover.
6 Reconnect all cables and power cords.
7 Turn on the display and computer.

If a POST Message is Displayed

If a POST error is detected when the PC starts, details of the error are
displayed. The BIOS offers two possibilities,
you can press
•
you can press
•
error.
It is recommended that you correct the error before proceeding, even if
the PC appears to start successfully. You should start Setup to verify
that the accessory which caused the error has been correctly configured.
to ignore the error and continue, or
to run Setup and correct the system configuration
5 Troubleshooting Your PC
If Your PC Does Not Start Properly
English 77