HP Compaq t1010 Supplementary Manual page 272

Modem AT Commands
Table 49–2:
Command
&B1
&C1
&D2
&F, &F0
&M0
&N, &N0
&Q5
&T4
&U1
&V
&W, &W0
&Y, &Y0
Table 49–3:
Command
\A3
\G, \G0
\J, \J0
\L, \L0
\N7
\Q3
49–2
AT Commands Beginning with "&"
Description
Disable port rate adjust
Carrier detect follows data carrier
Hang up and go to command mode during On-to-Off DTR
transition
Recall factory settings as active configuration
Asynchronous mode
Microcom QX/4232hs-compatible numeric result codes
displayed
Error Correction Mode V.42=> MNP=> Async
Grant request from remote for remote digital loopback test
Data compression enabled
View active configuration, profiles (0,1), and numbers
Save active configuration as User Profile 0
Recall User Profile 0 on power-up
AT Commands Beginning with "\"
Description
Maximum MNP block size = 256 characters
Disable port flow control DCE to DCE
Disable port rate adjust
MNP stream link
Set Auto-reliable mode (LAPM with fallback to MNP, then to
normal)
Bidirectional hardware flow control
Administrators Guide