Configuring The Coax Settings - NETGEAR MCA1001 - MoCA Coax-Ethernet Adapter User Manual

Coax-Ethernet Adapter MCA1001 User Manual
1. Select Password under Setup in the main menu. The Password screen displays.
Figure 3-9
2. In the Administrative Password fields, enter between 4 and 8 characters (no spaces) for your
new password, then confirm it by entering it again.
3. Click Apply to save your password setting.
Note: If you forget your password, use a pen to press the Reset button located on the back
of your Coax-Ethernet Adapter to factory default settings by holding it longer than
10 seconds; if LEDs are on, the Ethernet and Coax traffic LEDs will go off to
indicate when the Coax-Ethernet Adapter has finished resetting.

Configuring the Coax Settings

Note: Usually the default settings do not need to be changed, unless Technical Support
has specifically instructed you to adjust them.
You may want to change these settings for the following reasons:
3-12 Managing Your MCA1001 Coax-Ethernet Adapter Network
v1.0, December 2008