Coax-Ethernet Adapter Label - NETGEAR MCA1001 - MoCA Coax-Ethernet Adapter User Manual

Coax-Ethernet Adapter MCA1001 User Manual
Table 1-2. Connections, Buttons, and Port (continued)
Item
Mode button (Config/Normal)
Ethernet port
LED button (Off/On)
Reset button
Power outlet

Coax-Ethernet Adapter Label

The label on the bottom of the Coax-Ethernet Adapter shows the coax-ethernet adapter's MAC
address, serial number, and factory default login information.
Figure 1-3
1-4
Description
• Press button in (in position) to put the Coax-Ethernet Adapter into
Configuration Mode. (The Coax-Ethernet Adapter does not send or
receive traffic while in this mode—for more information, see
Chapter 3, "Managing Your MCA1001 Coax-Ethernet Adapter
Network.")
• Press button to release (out position) to set the Coax-Ethernet
Adapter to Normal Mode.
Connect Ethernet cable to a router, computer, network attached
storage (NAS) unit, gaming console, or other Ethernet enabled device.
• Press button in (in position) to deactivate all LEDs; this affects LEDs
only, the Coax-Ethernet Adapter still operates normally.
• Press button to release (out position) to activate all LEDs.
• Restart by pressing less than 10 seconds.
• Reset to factory default settings by pressing longer than 10 seconds;
if LEDs are on, the Ethernet and Coax traffic LEDs will go off to
indicate when the Coax-Ethernet Adapter has finished resetting.
Connect power.
Getting to Know Your Coax-Ethernet Adapter
v1.0, December 2008