Updating Your Coax-Ethernet Adapter Firmware - NETGEAR MCA1001 - MoCA Coax-Ethernet Adapter User Manual

Coax-Ethernet Adapter MCA1001 User Manual
2. Press the coax-ethernet adapter's Mode Config/Normal button to release it (out position) to
return it to normal mode.
3. Reconnect the Coax-Ethernet Adapter to your network (see
4. Restore your computer to its network settings by doing one of the following:
• If your computer had a fixed IP before configuring the Coax-Ethernet Adapter, restore this
IP address.
• If you use DHCP in your network (you usually allow your computer's IP address to be set
automatically), but still cannot communicate with your network after you re-connect the
computer, force a reset of your IP address by first disabling and then enabling your
network connection.

Updating Your Coax-Ethernet Adapter Firmware

The firmware of the Coax-Ethernet Adapter is stored in flash memory, and can be updated as
NETGEAR releases new firmware.
To check for and install new firmware to your coax-ethernet adapter:
3-6 Managing Your MCA1001 Coax-Ethernet Adapter Network
v1.0, December 2008
Figure 2-2 on page 2-3).