Table of Contents
Advertisement
•
To enhance your MoCA network security. If the Coax-Ethernet Adapters shown in the
MoCA Devices menu (see
intended to be part of your MoCA network, it means some other user has connected to the
network. You can either change the encryption key (see
or change the channel frequency as described in this section to resolve the issue. However,
changing the channel frequency may slow the speed of your network because multiple MoCA
networks share the bandwidth on a given channel.
•
To improve TV reception quality. If TV quality is reduced after the Coax-Ethernet Adapter
is installed, changing the channel frequency may fix it.
To change the diplexer mode and channel frequency:
1. Select Coax under Setup in the main menu. The Setup screen displays.
Figure 3-10
2. From the drop-down list, select MoCA D Band or All Pass.
Warning: The All Pass diplexer mode does not allow TV Service if you have
3. To change the channel setting, do one of the following:
Managing Your MCA1001 Coax-Ethernet Adapter Network
"Viewing Statistics" on page
devices connected by the TV OUT connection to the Coax-Ethernet
Adapter. If you select this mode, these devices will not receive the cable
TV signal when the coax-ethernet adapter is returned to normal operation.
v1.0, December 2008
Coax-Ethernet Adapter MCA1001 User Manual
3-8) include a device which is not
"Setting Up Security" on page
3-10),
3-13
Advertisement
Table of Contents
