Isdn Handset; Felcom 30 Starts Up - Furuno Felcom 30 Operator's Manual

2. OPERATION FROM HANDSET
2.4

ISDN Handset

When connected initially, the handset is automatically set to Fleet mode,
providing an idle display as shown on next section.
To switch back to ISDN Handset mode, press and hold down
ON power.
Switching back to Fleet mode is then achieved as follows:
1. Open the MENU and scroll down
to Reset to Fleet
2. Press
The handset will now
stay in Fleet mode.
2.5

FELCOM 30 starts up

FELCOM 30 automatically initializes the system and searches for the satellite.
See "3.2 Satellite search" in this manual to restart a search manually.
If required, see "3.4 Selecting default Net service provider".
Idle
When idle, the ISDN Handset displays as follows.
The alarm indicator flashes when an alarm condition occurs. The indicator stops
once the alarm has been read in the Display Handset by pressing
Information > Alarms & messages".
The indicator continues to be displayed if the alarm condition persists.
Note: If the searching begins suddenly due to satellite blocking, restart a search
manually, specifying your ocean region. See page 3-3 for details.
2-4
.
OK
Furuno Fleet
Waiting
Euro-ISDN
Ocean Region
Service provider
Signal strength
indicator
KDD IOR
Initializing KDD
Searching
KDD IOR
Ready for call
Alarm indicator
when turning
DEL
>Active MSN
MENU
Kayclick
Ringer
Answer beep
Backlight
Language
MSN
Protocol
SW version
OK
Reset to Fleet
IOR
KDD IOR
Ready for call
>
MENU