How To Set The Video Display; How To Select The Input Source; How To Cycle Your Video Inputs - Furuno MFD12 Operator's Manual

9. Camera/Video
9.2

How to Set the Video Display

9.2.1

How to Select the Input Source

You can select the input source from the menu or with the RotoKey. Below is the pro-
cedure with the RotoKey.
1. Activate the camera mode then push the RotoKey.
2. Rotate the RotoKey to select [Vid Source] then push the RotoKey. The selec-
tions are as follows:
3. Select each input source (Input1 - Input2).
4. Push the RotoKey to select or deselect the input.
9.2.2

How to Cycle Your Video Inputs

You can browse all the images that you receive. Use this feature to monitor the area
around your vessel, engine room, etc. with an on-board camera.
1. Press the MENU key.
2. Open the [Camera] menu.
3. Use the RotoKey to select [Scrolling Cycle 1].
4. Use the RotoKey to select the inputs to cycle.
5. Set up [Scrolling Cycle 2] similarly.
6. Press the MENU key to close the menu.
To select the cycle, show the soft controls, use the RotoKey to select [Vid Cycle] then
select [Cycle 1] or [Cycle 2] as.
9-2
PINP1
PINP2
IP1
IP2
IP3
IP4