Wall Mounting - HP J4850A Installation And Getting Started Manual

Wall Mounting

The mounting brackets supplied with the switch allow you to mount it on a
wall. The illustrations below show mounting a Switch 5308xl/5372xl. The
Switch 5304xl/5348xl would be mounted in a similar way.
C a u t i o n
For safe operation, do not install the switch with the vents or fans facing
downward. The only recommended and supported wall mounting orientation
is with the unit upright and the modules facing out, as shown in the illustra-
tions below.
Additionally, the switch should be mounted only to a wall or wood surface
that is at least 1/2-inch plywood or its equivalent.
1.
2.
Use a #1 Phillips
(cross-head)
screwdriver and
attach the
mounting brackets
to the switch with
the included
10-mm M4 screws.
Figure 2-11. Attaching brackets to the rear of the
Attach the
switch to the
wall or wood
surface with four
5/8-inch number
12 wood screws
or larger (not
included).
Figure 2-12. Mounting to a wall
Installing the Switch 5300xl Series
10 mm
M4 screws
switch
Installation Procedures
5/8-inch
number 12
wood screws
2-17