HP J4850A Installation And Getting Started Manual page 29

1.
insert module into the
guides and slide it in until
it is fully inserted.
Figure 2-1. Installing a module
the module is fully inserted when the
module bulkhead is contacting, or
very close to contacting
the face of the switch.
Figure 2-2. Tighting module retaining screws
Installing the Switch 5300xl Series
Installation Procedures
"Low-force" connector.
High insertion force is not
needed and should not be
2.
then tighten the retaining screws on
the module until they are secure, but do
not overtighten them.
used.
2-9