Cisco Vpn Server - Cisco SR520-FE-K9 Administration Manual

Configuring VPN

Cisco VPN Server

Cisco VPN Server
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
This section describes how to configure the server polices, settings, and users for
the Cisco VPN Server. The Cisco VPN Server allows remote users to access
private servers at a central site from anywhere on the Internet. Data is passed
through an encrypted IPSec VPN tunnel by using the Cisco VPN Client
See: www.cisco.com/go/vpnclient
Only the VPN Server, or site-to-site VPN can be used at a time on the SRP. If you
enable VPN Server, site-to-site VPN is disabled.
Configuring Groups-
Use the group page to configure the settings that control the Cisco VPN server
and the IPSec policies for communication with remote users.
Click VPN > Cisco VPN Server > Group. The Group window opens.
Click Enable to activate the VPN server. The default is Disable.
Under Identity, specify the Group Name and Password.
If necessary, make changes to the IKE Phase 1 and IKE Phase 2 settings to match
the desired IPSec policies.
Specify the Mode Configuration settings. The SRP520 models support up 5
concurrent connections /IP address assignments.
a. Set the DNS1 field to the primary DNS server address. Optionally, enter a
backup DNS server in the DNS2 field.
b. If necessary, specify the WINS servers to use.
c. (Optional) Enter a welcome message in the Banner field if desired. This
message is displayed to the VPN client user once the VPN session is
established.
Click Submit to save your settings.
7
191