Firmware Upgrade - Cisco SR520-FE-K9 Administration Manual

6
134
Log Resync
Success Msg
Log Resync Failure
Msg
Report Rule

Firmware Upgrade

Voice > Provisioning > Firmware Upgrade
Upgrade Enable
Upgrade Error Retry
Delay
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
Syslog message issued upon successful completion of
a resync attempt.
The default is $PN $MAC – Successful resync
$SCHEME://$SERVIP:$PORT$PATH -- $ERR.
Syslog message issued after a failed resync attempt.
The default is $PN $MAC – Resync failed: $ERR.
The target URL to which configuration reports are sent.
This parameter has the same syntax as the Profile_Rule
parameter, and resolves to a TCP/IP command with an
associated URL.
A configuration report is generated in response to an
authenticated SIP NOTIFY message, with Event: report.
The report is an XML file containing the name and value
of all the device parameters.
This parameter may optionally contain an encryption
key.
For example:
[ --key $K ] tftp://ps.callhome.net/$MA/rep.xml.enc
The default is (empty).
Enables firmware upgrade operations independently of
resync actions.
The default is Yes.
The upgrade retry interval (in seconds) applied in case
of upgrade failure. The device has a firmware upgrade
error timer that activates after a failed firmware upgrade
attempt. The timer is initialized with the value in this
parameter. The next firmware upgrade attempt occurs
when this timer counts down to zero.
The default is 3600 seconds.
Configuring Voice
Configuring Voice Settings