Cisco SR520-FE-K9 Administration Manual page 139

Configuring Voice
Configuring Voice Settings
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
Prompt Tone
Busy Tone
Reorder Tone
Off Hook
WarningTone
Ring Back Tone
Ring Back 2 Tone
Confirm Tone
SIT1 Tone
Prompts the user to enter a call forwarding phone
number.
The default is 520@-19,620@-19;10(*/0/1+2).
Played when a 486 RSC is received for an outbound call.
The default is 480@-19,620@-19;10(.5/.5/1+2).
Played when an outbound call has failed, or after the far
end hangs up during an established call. Reorder Tone is
played automatically when Dial Tone or any of its
alternatives times out.
The default is 480@-19,620@-19;10(.25/.25/1+2).
Played when the caller has not properly placed the
handset on the cradle. Off Hook Warning Tone is played
when the Reorder Tone times out.
The default is 480@10,620@0;10(. 1 25/. 1 25/1+2).
Played during an outbound call when the far end is
ringing.
The default is 440@-19,480@-19;*(2/4/1+2).
Your SRP plays this ringback tone instead of Ring Back
Tone if the called party replies with a SIP 182 response
without SDP to its outbound INVITE request. The default
value is the same as Ring Back Tone, except the
cadence is 1s on and 1s off.
The default is 440@-19,480@-19;*(1/1/1+2).
Brief tone to notify the user that the last input value has
been accepted.
The default is 600@-16; 1(.25/.25/1).
Alternative to the Reorder Tone played when an error
occurs as a caller makes an outbound call. The RSC to
trigger this tone is configurable on the SIP screen.
The default is 985@-16,1428@-16,1777@ 16;20(.380/0/
1,.380/0/2,.380/0/3,0/4/0).
6
139