Cisco SR520-FE-K9 Administration Manual page 145

Configuring Voice
Configuring Voice Settings
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
Hook Flash Timer
Max
Callee On Hook
Delay
Reorder Delay
Call Back Expires
Call Back Retry Intvl
Call Back Delay
VMWI Refresh Intvl
Interdigit Long Timer
Maximum on-hook time before off-hook qualifies as
hookflash. More than this the on-hook event is treated as
onhook (no hook-flash event). Range: 0.4–1.6 seconds.
The default is 0.9.
Phone must be on-hook for at this time in sec. before the
SRP will tear down the current inbound call. It does not
apply to outbound calls. Range: 0–255 seconds.
The default is 0.
Delay after far end hangs up before reorder tone is
played. 0 = plays immediately, inf = never plays. Range:
0–255 seconds.
The default is 5.
Expiration time in seconds of a call back activation.
Range: 0–65535 seconds.
The default is 1800.
Call back retry interval in seconds. Range: 0–255
seconds.
The default is 30.
Delay after receiving the first SIP 18x response before
declaring the remote end is ringing. If a busy response is
received during this time, the SRP still considers the call
as failed and keeps on retrying.
The default is 0.5.
Interval between VMWI refresh to the CPE.
The default is 0.
Long timeout between entering digits when dialing. The
interdigit timer values are used as defaults when dialing.
The Interdigit_Long_Timer is used after any one digit, if
all valid matching sequences in the dial plan are
incomplete as dialed. Range: 0–64 seconds.
The default is 10.
6
145