Cisco SR520-FE-K9 Administration Manual page 51

Setting up the Interfaces of the Services Ready Platforms
Setting up the Wireless LAN
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
Basic Wireless Settings
Field Description
Standard If you selected Wide-40MHz Channel or Standard -20MHz
Channel Channel for the Radio Band setting, then this setting will be
available. Select the channel for Wireless-N, Wireless-G, and
Wireless-B networking.
If you selected Wide-40MHz Channel for the Radio Band
setting, then the Standard Channel will be a secondary
channel for Wireless-N. The default is channel 11. If radio
band is selected automatically, the standard channel will also
be chosen automatically.
Wireless Table
Wireless Name of the network that clients use when connecting to the
Network Name network.
(SSID)
By default wireless network is named "cisco-data" and is
connected to the default VLAN. To rename the default
wireless network, enter a unique Wireless Network Name,
which is case-sensitive and must not exceed 32 characters
(use any of the characters on the keyboard).
The second default wireless network has the default name
"cisco-voice" and is bridged to the voice VLAN. To create a
second wireless network, enter a unique Wireless Network
Name in the SSID2 setting. To activate this network, select
Enabled Network.
NOTE
SSID2 settings. Contact your ISP or ITSP for more information.
SSID1/2/3/4 Network name shared among all devices in a wireless
network. The SRP can support up to four wireless networks.
By default, the first and second wireless networks are
enabled, and you can enable two other wireless networks if
needed.
For each wireless network you need to configure the
Wireless Network Name (SSID), Broadcast Network Name,
and Enable Network option.
Your ISP or ITSP may be responsible for controlling the
4
51