Wireless Protected Setup; Wps Method 1 - Cisco SR520-FE-K9 Administration Manual

Setting up the Interfaces of the Services Ready Platforms
Setting up the Wireless LAN
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
Field Description
Key Renewal Enter an interval in seconds to specify how often the SRP
Timeout changes the encryption keys. The default Group Key
Renewal period is 3600 seconds, which is 1 hour.

Wireless Protected Setup

Use the Wi-Fi Protected Setup page to automatically configure wireless security
for your wireless networks.
Make sure that the WPS client device is located near the SRP during setup.
Click Interface Setup > Wi-Fi Settings > Wi-Fi Protected Setup. The Wi-Fi
Protected Setup window opens.
To enable WPS for an individual SSID, choose the name of the wireless network
that you want configure from the drop-down list. The default data SSID is cisco-
data. The default voice SSID is cisco-voice.
WPS is enabled by default. Select Disabled if you don't want to use this feature for
the selected VLAN.
Choose a Wi-Fi Protected Setup method. The current Wi-Fi Protected status is
displayed at the bottom of the page.
There are three methods to configure your WiFi settings by using WPS. Use the
method that applies to the client device that you are configuring.

WPS Method 1

Use this method if your client device has a Wi-Fi Protected Setup button.
Click or press the Wi-Fi Protected Setup button on the client device.
Click the Wi-Fi Protected Setup button on this page., or press the Wi-Fi protected
Setup button on the SRP520 top panel, if that was associated with the currently
selected SSID. See Basic Wireless Settings, page
After the client device is configured, click OK. Then refer to your client device or its
documentation for further instructions.
49.
4
55