Mobile Network - Cisco SR520-FE-K9 Administration Manual

Setting up the Interfaces of the Services Ready Platforms
Setting up the WAN Interface
STEP 1
STEP 2
STEP 3
NOTE
STEP 4
STEP 5
STEP 6
NOTE
STEP 7
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)

Mobile Network

Use the Mobile Network page to configure your SRP to connect to a Mobile
Broadband USB modem that is connected to its USB interface. For information
about compatible modems see: www.cisco.com/go/srp500.
Click Interface Setup > Mobile Network. The Mobile Network window opens.
Connect to the USB Modem. If the card is supported by the SRP, it is automatically
detected and appears on the Mobile Network page.
Select Auto or Manual connection mode. The default mode is Auto.
• To enable your modem to establish a connection automatically, select Auto
mode.
• To connect or disconnect your modem connection manually, select Manual
mode.
Ethernet Connection Recovery works only if the Connection Mode is set to Auto. If
you select Auto, you must also select either Connect on Demand or Keep Alive.
Verify that the Card Status field shows the status of your mobile card.
If required, select a tunnelling protocol to configure for the interface.
If necessary, change any mobile network settings in the Mobile Network Setup
area.
You must click the Manual option in the Configure Mode field to manually setup your
mobile network card.
Click Submit to save your settings
4
36