Table of Contents
Advertisement
Configuring the Interfaces
Configuring Multilink PPP Minimum Links Mandatory
To configure the Multilink PPP Minimum Links Mandatory feature, use the following commands in
interface configuration mode:
Command
Step 1
Router(config-if)# ppp multilink
Step 2
Router(config-if)# multilink min-links
links mandatory
This example shows how to configure the Multilink PPP Minimum Links Mandatory feature:
Router(config-if)# ppp multilink
Router(config-if)# multilink min-links 5 mandatory
For additional information about the Multilink PPP Minimum Links Mandatory feature, refer to this
URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121limit/121e/121
e11/12e_mlp.htm#xtocid0
The commands listed at this URL are all supported on the OSM-12CT3/T1, except the following:
•
•
•
•
Verifying the Configuration
Use the show ppp multilink command to display information about the newly created multilink bundle:
Router# show ppp multilink
Multilink1, bundle name is group1
Bundle is Distributed
0 lost fragments, 0 reordered, 0 unassigned, sequence 0x0/0x0 rcvd/sent
0 discarded, 0 lost received, 1/255 load
Member links:4 active, 0 inactive (max not set, min not set)
Serial1/0/0:1
Creating a Multilink Interface Example
Interface multilink1
ip address 100.0.0.1 255.255.255.0
interface serial6/12/1:0
no ip address
encapsulation ppp
Optical Services Modules Installation and Configuration Note, 12.2SR
7-14
multilink max-link
multilink load-threshold
multilink max-fragments
debug ppp multilink fragments
Chapter 7
Configuring the Channelized 12-port CT3/T1 Optical Services Modules
Purpose
Enables Multilink PPP.
Specifies the required minimum number of links in a Multilink
PPP (MLP) bundle. If the minimum number of links in the MLP
bundle falls below the number specified by the links attribute, the
MLP bundle is disabled.
links—Minimum number of links, in the range 0 to 12.
•
The mandatory keyword is required on the OSM-12CT3/T1.
•
OL-9465-03
Advertisement
Table of Contents
