BVM Tomahawk Hawk 100 Construction And Operation Manual page 15

Hawk 100
This is the small trailing cover for the Aileron Linkage.
Using tape and a pencil mark the location of the
cover. Then cut out the area where you will apply the
glue.
Use a small drill bit to make some anchor holes in
the Aileron as well as the cover itself. Using QT-
Poxy secure the cover to the Aileron.
One side completed and ready to move to the Flap
Hinge covers. The other wing will be the same
steps.
BVM ©2023 14 4/2023