Icom IC-756 Instruction Manual page 59

E Miscellaneous (others) set mode (continued)
Beer Citonatirmak ion?
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set in level set mode. (p. 54)
SF
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set in level set mode. (p. 54)
San SP eed
The transceiver has 2 speeds for scanning, high and
low.
See p. 47 for scanning details.
Stan TESKE
This item sets the scan resume function ON or OFF.
ON: scan resumes 10 sec. after stopping on a signal
(or 2 sec. after a signal disappears); OFF: scan does
not resume after stopping on a signal.
See p. 47 for scanning details.
re StL onkran l
The [RF/SQL] control can be set as the RF/squelch
control (default), the RF gain control only (squelch is
fixed as open) or squelch control (RF gain is fixed at
maximum).
See p. 2 for details.
Buick dualwatch
When this item is set to ON, pushing [DUALWATCH]
for 2 sec. sets the sub readout frequency to the main
readout frequency and activates dualwatch operation.
See p. 30 for details.
Babak SP Lit
When this item is set to ON, pushing [SPLIT] for 2
sec. sets the sub readout frequency to the main read-
out frequency and activates split operation.
See p. 32 for details.
ON
Confirmation beep ON
(default)
-v
ON
Band edge beep ON
(default)
HIGH
High speed (default)
ON
Scan resume ON
(default)
RF+S@QL
SET MODE 8
OFF
Confirmation beep OFF
OFF
Band edge beep OFF
LOW
Low speed
OFF
Scan resume OFF
{RF/SQL] control as RF/squelch control
(default)
RF [RF/SQL] control as RF gain control
[RF/SQL] control as squelch control
ON
Quick dualwatch ON
(default)
ON
Quick split ON
(default)
OFF
Quick dualwatch OFF
OFF
Quick split OFF
56