Table of Contents
Advertisement
Laser Safety
Among the modules supported by RG-S8614/S8610/S8606/S8606 B, there are a great number of optical modules that
are Class I laser products. Therefore, pay attention to the following during your use of this product:
When a fiber transceiver works, ensure that the port has been connected with an optic fiber so as to keep out dust
and avoid burning your eyes.
Cover the unused optical ports with dust caps.
Do not stare into any optical port.
Do not get close to or stare into any optical port under any circumstances, as this may cause permanent damage to
your eyes.
Installation Site Requirements
RG-S8614/S8610/S8606/S8606 B must be used in the room. To ensure normal operation and a prolonged use life of the
equipment, the installation site must meet the following requirements.
Rack Mounting Requirements
To mount the RG-S8614/S8610/S8606/S8606 B in a frame, verify that the frame meets the following conditions:
Install the switch in an open cabinet as much as possible. If you install the switch inside an enclosed cabinet, be sure
that the cabinet has a good ventilation and heat dissipation system.
Be sure that the cabinet is firm enough to bear the weight of the RG-S8614/S8610/S8606/S8606 B and its
installation accessories.
Be sure that the dimensions of the cabinet is appropriate for installation of the RG-S8614/S8610/S8606/S8606 B that
can reserve a certain space for the front, rear, left and right panels for heat dissipation.
The frame should be properly grounded.
Ventilation and Heat Dissipation Requirements
Sufficient space (10 cm at least) must be reserved at the air intakes and exhaust vents for ventilation.
After connecting various cables, you should bundle the cables or place them in the cable management bracket to
avoid blocking air inlets.
Advertisement
Table of Contents
