Safety; General Safety Rules; Indoor/Outdoor Use - Magicfx LIQUID FLAME SYSTEM User And Installation Manual

2

SAFETY

The LIQUID FLAME SYSTEM has been designed and constructed in such a manner that
it can be used safely. This applies to the use, the circumstances and the regulations
as described in this documentation. Reading this documentation and following the
instructions are therefore necessary for everyone who is authorised to work with the
LIQUID FLAME SYSTEM.
The LIQUID FLAME SYSTEM must be used in surroundings that:
• Have a reasonably stable temperature of between -10 and 50 °C;
• Have a relative humidity degree between 20 % and 90 % (non condensing);
• Are free of dust, corrosive gases and high concentrations of organic vapours.
2.1

GENERAL SAFETY RULES

• Only authorised persons may carry out work with the LIQUID FLAME SYSTEM.
• Do not use the LIQUID FLAME SYSTEM if there are people or animals in the
direct output.
• Do not use the LIQUID FLAME SYSTEM if alterations have been made other
than by or on behalf of MAGICFX
• Make sure that children, unauthorised people and animals do not obtain
access to the LIQUID FLAME SYSTEM.
• Make sure there are no freestanding objects or objects that can be damaged
by the system within the output distance.
• Do not connect more units to a single electrical circuit than the installed fuse
is able to handle. (Calculate the summed load with the electrical data from
Chapter 1)
• Do not remove any safeguards, safety caps and safety symbols.
• All required safety devices must be in good condition and function properly.
• Ensure sufficient lighting of the surroundings.
• Keep the workplace clean.
2.2

INDOOR/OUTDOOR USE

The LIQUID FLAME SYSTEM is designed for outdoor use or use in large well-ventilated
indoor spaces. Keep the prescribed output zone clear for safe release of the flames
and their heat. For specific safety requirements, refer to the corresponding user and
installation manual(s) of the used flame head(s).
WARNING
Do not use the LIQUID FLAME SYSTEM in poor ventilated confined
spaces. Exposure to accumulated heat and combustion fumes
may cause inhalation of hazardous particles and gases, and
cause eye and skin irritation.
MAGICFX LIQUID FLAME SYSTEM
.
®
— User and Installation Manual
®
17