Installation Site Requirements; Bearing; Space; Ventilation - Ruijie Reyee RG-RAP72Pro Installation Manual

RG-RAP72Pro Installation Guide

Make sure that the AP is powered off when you cut off the power supply.

Do not place the AP in a wet position, and keep it away from liquid.

Keep the AP far away from grounding or lightning protection devices for power equipment.

Keep the AP away from radio stations, radar stations, high-frequency and high-current devices, microwave
ovens, and other high-power wireless devices.
2.2

Installation Site Requirements

The RG-RAP72Pro must be used indoors. For normal operation and prolonged service life of the access point,
the installation site must meet the following requirements.
2.2.1

Bearing

Ensure that the installation site is firm enough to support the weight of the RG-RAP72Pro and its accessories.
2.2.2

Space


The AP should be installed in an open environment if possible. If the AP is to be installed in an enclosed
environment, ensure that a good ventilation and heat dissipation system is available.

Ensure that the installation site has sufficient space for heat dissipation.
2.2.3

Ventilation

The RG-RAP72Pro adopts natural cooling. When installing the AP, ensure that there is sufficient space in front,
back, left, and right of the AP for heat dissipation.
2.2.4

Temperature and Humidity

To ensure that the RG-RAP72Pro works properly and has a long service life, maintain a proper temperature and
humidity in the working environment. Improper room temperature and humidity can cause damage to the AP.

High relative humidity may affect insulation materials, resulting in poor insulation and even electrical leakage.
Sometimes it may lead to changes in the mechanical properties of materials and corrosion of metal parts.

Low relative humidity can dry and shrink insulation sheets and cause static electricity that can damage the
circuitry.

High temperatures greatly reduce device reliability and shorten service life.
2.2.5

Cleanliness

Dust poses a major threat to the device. The indoor dust can cause electrostatic adhesion when falling on the
device, causing poor contact of the metallic joint. Such electrostatic adhesion occurs more easily when the
indoor relative humidity is low, not only affecting the service life of the device, but also causing communication
failure easily. The following table lists the requirements on the dust content and diameter in the equipment room.
Table 2-1 Dust and Particles
Particle Size
≥ 0.5 μm
≥ 1 μm
Unit
3
Particles/m
3
Particles/m
9
Preparing for Installation
Content
≤1.4 x 10
7
≤7 x 10
5